Manual para PLV-Z2

Name: Manual para PLV-Z2
Brand: SANYO
Availability: InStock

Marca: SANYO

Categoría: Video

Tipo de Documento: Manual

Idioma: ES

Idiomas Disponibles: EN , ES

Subido: 21 de noviembre de 2025 a las 19:11

Información de Garantía

Contact the dealer or service center for warranty information.

Complete all peripheral connections before turning on the projector.
Connect the AC power cord, turn the Main On/Off switch on, and then press the POWER ON-OFF button.
The POWER indicator turns green, and the cooling fans start. A preparation display appears, followed by the selected input source and lamp mode status.

Press the POWER ON-OFF button. A "Power off?" message appears.
Press the POWER ON-OFF button again to turn off the projector. The POWER indicator flashes red while cooling fans operate (approx. 90 seconds).
Wait for the POWER indicator to light red before disconnecting the AC power cord.

Note: Allow at least 5 minutes before turning off after turning on to maintain lamp life. Do not disconnect AC power during the cooling period.

Problem:	Solutions:
No power	- Plug the power cord into the AC outlet. - Check if the front cover is open and the POWER indicator lights red. - See if the Main On/Off switch is on. - Wait 90 seconds after turning OFF before turning ON again. - Check the WARNING indicator. - Check the projection lamp. - Ensure the projector is on a flat surface.
Image is out of focus.	- Adjust focus of the projector. - Provide proper distance between projector and screen. - Check and clean the projection lens. - Allow condensation to dissipate if the projector was moved between temperature locations.
No image	- Check connections between video equipment/computer and projector. - Verify input signal is outputting correctly from the computer. - Some laptops may require monitor output settings adjustments. - Allow up to 30 seconds for an image to display. - Select the correct input source. - Ensure operating temperature is within range (5°C ~ 35°C).
Image is Left/Right reversed.	- Check the Ceiling / Rear setting.
Image is Top/Bottom reversed.	- Check the Ceiling setting.
Some displays are not seen during the Operation.	- Check the Display item setting.
The Remote Control does not work.	- Check the batteries. - Ensure no obstruction between projector and remote. - Do not be too far from the projector (max 16.4' / 5m). - Ensure the remote control code matches the projector's.